![]() This is a type of permanent shank for use with polishing, cutting, or sanding bits. ![]() In some cases, you will need to use a mandrel, a type of shank with a threaded head.You can also get collets in different sizes for use with different sized accessory shanks.Some models are equipped with collets designed for quick and easy connection and release. ![]() Make sure to practice inserting and changing the bit when the Dremel is turned off and unplugged.This should loosen the bit so you can replace it. To remove the bit, press down on the shaft lock button while turning the collet. Tighten the collet nut so that the bit is secure and doesn’t wiggle. Practice inserting and securing bits. To insert a bit, place the bit into the hole at the end of the Dremel and back it out slightly. You should also keep children and other people away while you’re operating the tool. You should also wear safety glasses, especially when cutting, polishing, or grinding with the Dremel. Gloves will keep your hands safe from debris and sharp edges. Wear proper safety gear. Always wear work or rubber gloves when you run the Dremel. Let the wheel reach full speed and carefully re-enter the cut. Do not restart the cutting operation in the workpiece.Do not attempt to make an excessive depth of cut.Maintain a firm grip on the power tool and position your body and arm to allow you to resist kickback forces.Kickback is the result of power tool misuse and/or incorrect operating procedures or conditions and can be avoided by taking proper precautions as given below. Kickback is a sudden reaction to a pinched or snagged rotating wheel,īacking pad, brush or any other accessory.Do not operate the power tool near flammable materials.Never lay the power tool down until the accessory has come to a complete stop.Clamping a small object allows you to use both of your hand(s) to control the tool. Never hold a small object in one hand and the tool in the other hand while in use.Fragments of material or of a broken accessory may fly away and cause injury beyond immediate area of operation. Anyone entering the work area must wear personal protective equipment.Use face shield, safety goggles or safety glasses.Position yourself and bystanders away from the plane of the rotating accessory.Mandrel mounted wheels, sanding drums, cutters or other accessories must be fully inserted into the collet or chuck.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |